Re: [TenTec] Orion II firmware problems

["Ron Castro" <ronc@sonic.net>]

I found that 2.037j worked fine with both the new and previous version of 
the N4PY software.  Maybe my computer is more tolerant of the baud rate. I'm 
using a cheap USB to serial converter into a laptop.
Ron N6AHA

----- Original Message ----- 
From: "Carl Moreschi" <n4py@arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, October 08, 2006 7:20 PM
Subject: Re: [TenTec] Orion II firmware problems


> There seems to be an issue with some Orion II's with 2.037j that causes 
> the
> baud rate to be off a little.  The fix is to set the baud rate at 56000 
> baud
> instead of 57600.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
> ----- Original Message ----- 
> From: "David E. Shelton" <des.n4in@gmail.com>
> To: <tentec@contesting.com>
> Sent: Sunday, October 08, 2006 7:46 PM
> Subject: [TenTec] Orion II firmware problems
>
>
> > Is it just me or does the current version of FW 2.037j have some issues
> with
> > computer interfacing the Orion II. I can't get DX4WIN, MixW, WriteLog, or
> > several others to interface smoothly with 2.037j. I reverted back to 
> > 2.034
> > and the problems are gone. When will this be fixed? I looks like the FW
> was
> > released September 7. This is a fairly significant problem that would
> affect
> > about everyone with these rigs. Is there a work around other than using
> > 2.034? Thanks,
> > David, N4IN
> >
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec