| To: | "TenTecReflector" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] LDG 0T-11P |
| From: | "Ron" <ron@morell.us> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 7 Oct 2006 13:30:34 -0600 |
| List-post: | <mailto:tentec@contesting.com> |
Hello Reflector, OK, the LDG 0T-11P auto tuner is installed and working in the O2. Does not seem to work correctly with the N4PY software internal tuner setup, but other than that, it is working very well. The directions were well written and pretty much covered the subject with enough detail for me to succussfully install the unit. these directions did not provide much direction on how to locate the screw I dropped on the floor, but I improvised and looked for it, until it was located. Ron KA7U |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Trade IC-7000 for Omni 6 Plus?, NZ8J |
|---|---|
| Next by Date: | [TenTec] 6N2 VALUE?, William Evans |
| Previous by Thread: | [TenTec] Trade IC-7000 for Omni 6 Plus?, NZ8J |
| Next by Thread: | [TenTec] 6N2 VALUE?, William Evans |
| Indexes: | [Date] [Thread] [Top] [All Lists] |