Tnx for the replies. Yes, I think I had mine set for 8. i will leave it at
8 for now, pending any more opinions.
73 de Jack W4TJE
> [Original Message]
> From: Robert Carroll <w2wg@comcast.net>
> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Date: 9/17/2006 12:05:43 PM
> Subject: Re: [TenTec] cw settings O2
>
> The conclusion of the click analysts for the earlier releases was that you
> need at least 8msec not to click--and that the TenTec numbers are off more
> or less by a factor of 2. I haven't heard whether or not this is the case
> with the latest release.
>
> Bob W2WG
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of RaySoifer@cs.com
> Sent: Sunday, September 17, 2006 11:22 AM
> To: w4tje@earthlink.net; tentec@contesting.com
> Subject: Re: [TenTec] cw settings O2
>
> In a message dated 9/17/06 12:46:24 PM Greenwich Standard Time,
> w4tje@earthlink.net writes:
> > Good morning. I accidently reset the Orion 2 to the default settings.
> > Now, I cannot remember what setting has been recommended for cw rise
fall
> > time. I think it is a setting of 8 to 10 ms.
> >
> Mine is set for 5 ms.
>
> 73,
>
> Ray W2RS
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|