| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Orion II 2.037j NB glitch |
| From: | "Grant Youngman" <nq5t@comcast.net> |
| Reply-to: | nq5t@comcast.net,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 15 Sep 2006 18:05:18 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
> I just noticed that I can no longer switch between software and > hardware noise blankers by holding the NB button. Have to go to RX > menu to turn HW NB on or off. It's working just fine here. I know that doesn't help much. But try again .... Grant/NQ5T _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Orion II 2.037j NB glitch, Robert Redmon |
|---|---|
| Next by Date: | Re: [TenTec] Orion II 2.037j NB glitch, George |
| Previous by Thread: | [TenTec] Orion II 2.037j NB glitch, Robert Redmon |
| Next by Thread: | Re: [TenTec] Orion II 2.037j NB glitch, George |
| Indexes: | [Date] [Thread] [Top] [All Lists] |