Bill
I'm not sure this explanation holds water.
The 8 bit D to A will reduce that 1/10th dB resolution from the precision
arithmetic to 114/256 dB or just better than 1/2 dB. Unless the S-meter
movement is really bad, there's something else at work here.
73
Bob, 5B4AGN
> **********************************************
> At times my S-meter doesn't seem very accurate, why is that?
>
> Precision arithmetic is used to calculate the S-meter measurements
> and the (digital) output is extremely
> accurate. The digital S-meter readings can be read over the serial
> port using the ?S command. The
> s-meter numeric precision is roughly 1/10 of a dB.
>
> The analog meter is the analog representation of the digital S-meter
> result. The meter accuracy is affected
> by two things. First, the meter is electromechanical and subject to
> manufacturing and environmental
> variations. Second, the DSP/Logic board drives the meter through an
> 8-bit Digital-To-Analog converter
> which limits the meter to 256 steps.
> ***************************************************
>
> The PWR control seems to be fairly accurate
> except at the lowest settings. The minimum power I
> can set on my Orion is about 4 Watts at a setting of 1.
>
> 73, Bill W4ZV
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|