The 262 and that genre did not have a crowbar circuit to protect your
equipment from overvoltage. If you have a circuit failure in the
supply, you are likely to get 25 volts output to the rig.
Ten-Tec sold an overvoltage circuit board as an add-on. You can check
to see if you have one by looking where the large red wire connects to
the supply's output connector. If the board is installed, it will be
installed inside the back panel. It is constructed on a 1 x 2 inch
circuit board with a fuse, an SCR and a zener. Instructions say to cut
that red wire and connect it to the circuit board.
If your supply is not so equipped, there is a newer way to do the job.
All you do is fuse the output and then from the rig side of the fuse you
put a 1.5KE15A Transient Diode to ground. Our thanks to Ariel for the
tip. Follows his original email:
73, Mike N4NT
___________________________________________________________________
[TenTec] My second Ten Tec is a Triton IV.
from [Ariel M. Elam] [Permanent Link][Original]
To: <tentec@contesting.com>
Subject: [TenTec] My second Ten Tec is a Triton IV.
From: k4aal@comcast.net (Ariel M. Elam)
Date: Sun Apr 27 23:19:10 2003
Hello to all -- There is an article in "73 Amateur Radio Today", May
2002, Page 38, titled "An Ounce Of" that tells how to use a 1.5KE15A
Transient Diode to protect from overvoltage and spikes. Cheap,
too!
Simply fuse the + line comming from the supply and tie the diode across
the + and - before it reaches the load. Make sure the banded end of the
diode goes to + line after the fuse.
I've not used it, but it looks good.
Write if you want more details.
73, Ariel, K4AAL
____________________________________________________________________
----- Original Message -----
From: "D. Kemp" <nn8b@yahoo.com>
To: <tentec@contesting.com>
Sent: Wednesday, September 13, 2006 8:52 AM
Subject: Re: [TenTec] 262 Power Supply
| Thanks to everyone who replied on and off list.
|
| The Triton II is probably the rig this power supply is
| ment for.
|
| Now to find a Triton II.
|
| 73,
|
| Don, NN8B
[TenTec] My second Ten Tec is a Triton IV.
from [Ariel M. Elam] [Permanent Link][Original]
To: <tentec@contesting.com>
Subject: [TenTec] My second Ten Tec is a Triton IV.
From: k4aal@comcast.net (Ariel M. Elam)
Date: Sun Apr 27 23:19:10 2003
Hello to all -- There is an article in "73 Amateur Radio Today", May
2002, Page 38, titled "An Ounce Of" that tells how to use a 1.5KE15A
Transient Diode to protect from overvoltage and spikes. Cheap,
too!
Simply fuse the + line comming from the supply and tie the diode across
the + and - before it reaches the load. Make sure the banded end of the
diode goes to + line after the fuse.
I've not used it, but it looks good.
Write if you want more details.
73, Ariel, K4AAL
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|