Yep, same thing here! Still running pervious version of firmware, by the
way.
N5BLY
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Dale Barrett
Sent: Monday, September 11, 2006 6:31 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] Orion II Corrupted Display
I am having trouble with my display on my Orion II. Try the following
and see if this happens to you:
1.) Push the VFOB ENTER BUTTON
2.) Push the 0 digit
3.) Push the VFOB ENTER BUTTON
My display corrupts and the only way to fix it is to turn the rig off
and then back on.
I found this by accident when I pressed the VFOB ENTER BUTTON and then
the 0 digit by mistake and wanted to start over again. Please let me
know if this happens on anyone else's Orion II.
Thanks
Dale A. Barrett
WB7D - Murray Kentucky
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|