TenTec
[Top] [All Lists]

Re: [TenTec] 2.059 Headphone output level

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] 2.059 Headphone output level
From: "Carl Moreschi" <n4py@arrl.net>
Reply-to: Carl Moreschi <n4py@arrl.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 10 Sep 2006 18:38:35 -0400
List-post: <mailto:tentec@contesting.com>
I finally got back home and just installed version 2.059d.  What I am
finding is both the speaker and headphone volime require a higher setting
than 2.056.  On 2.056 I could set the volume to 50% and that was fine.  On
2.059d, I need to set the volume to 70% for both the speaker and headphones.
I don't see any problem with this, it just needs to be set to a higher
level.  On CW I find the sidetone volume and spot volume to be the same.  I
am running with the new setting for AGC set to flat and the hardware mic
gain set to 0.  I haven't heard any distorted audio yet or anything bad yet.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "Larry Menzel" <retire@means.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, September 10, 2006 5:13 PM
Subject: Re: [TenTec] 2.059 Headphone output level


> Yes, the headphone audio is down, but still not that bad.  However, I also
> notice, with all my phones, an artifact when keying cw.
>
> Anyone else hear that?  It's a serious clicking...no, more of a
> reverberation...like rf on the phone jack..  I don't get it through the
> speaker, however.
>
> Larry, N0XB
>
>
> ----- Original Message ----- 
> From: "David H. Walker" <k0cop@onlymyemail.com>
> To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
> Sent: Sunday, September 10, 2006 8:05 AM
> Subject: Re: [TenTec] 2.059 Headphone output level
>
>
> > It is considerably lower then previous version
> > David
> >
> > 73,K0COP
> >
> > David H. Walker
> > Aiken, SC
> > k0cop@onlymyemail.com
> > Virus scan by BitDefender
> > -----Original Message-----
> > From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]
> > On Behalf Of Barry Gross
> > Sent: Sunday, September 10, 2006 00:03
> > To: Discussion of Ten-Tec Equipment
> > Subject: [TenTec] 2.059 Headphone output level
> >
> >
> >
> > Anybody else experiencing a noticeable reduction in headphone output
> > level (volume) in 2.059, compared to v1?
> >
> > 73,
> > Barry N1EU
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
> >
> > --
> > If this email is spam, report it here:
> >
http://www.OnlyMyEmail.com/reportSpam?Id=MTY1ODI6MTY0ODkzODQxOmswY29wQG9ubHl
> > teWVtYWlsLmNvbQ%3D%3D
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>