Bill,
Have you been able to confirm the problem I've encountered? To reproduce:
1. Assign VFO B to main rx, any VFO to tx and subrx.
2. Place main rx in some mode, say LCW.
3. Place sub rx in another mode, say USB.
4. Exercise TUNE feature.
5. Observe mode of operation for main rx - main display won't be
refreshed if MAIN RX was last rx selection button pressed, in that
case press MODE and observe highlighted mode. Main rx will now be in
USB mode. Of course your ears will notice the change immediately. If
SUB RX was last rx selection button pressed then pressing MAIN RX will
force a display refresh and displayed mode will be USB.
Bob NW8L
On 9/10/06, Bill Tippett <btippett@alum.mit.edu> wrote:
<trimmed>
> Agreed...best ever V2 and nice to
> see some new features. Since the original
> V2 betas, this is the first version I'm
> leaving in rather than reverting to V1.
>
> Nice job Gary and team!
>
> 73, Bill W4ZV
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|