In a message dated 9/10/06 12:52:10 AM Greenwich Standard Time,
ronc@sonic.net writes:
> This was the fix we were waiting for to get the Speech Processor working
> right. I did some tests using an old Collins 302C-3 watt meter which has
> relatively slow meter ballistics. I yanked the bass out of my audio by
> setting
> the EQplus bass control to 0. With no processing and 1500 watts PEP out, the
> average peaks shown on the 302C-3 were around 30 Watts. Progressively
> increasing the SP from 1 to 9 increased the average peaks up to 200 Watts.
> By
> comparison, my trusty old Alpha Vomax pushed the average peaks to about
> 175-200.
>
I agree with Ron. With 2.034, it sounded pretty distorted with SP settings
higher than 3. Now I can go up to 4 or 5 with acceptable results.
Another problem I had with prior firmware, one that I haven't seen written
about here, concerned the DVK. The output level was much lower than it should
be. That has been fixed in 2.037j.
73,
Ray W2RS
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|