TenTec
[Top] [All Lists]

[TenTec] Audio Outputs Different V2.059 ?

To: <tentec@contesting.com>
Subject: [TenTec] Audio Outputs Different V2.059 ?
From: "Merle Bone" <merlebone@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 9 Sep 2006 13:56:33 -0500
List-post: <mailto:tentec@contesting.com>
Barry N1EU said:
" With speech processor off, the audio quality seems
uniformly excellent.  However the speech processor is VERY aggressive
and its effects quite audible.   With v1 firmware, I often ran SP at 5
to 8.  With 2.059, I'm not sure if I'll be using it at all.  Curious
what others find."

I think there have been some improvements in the performance of 2.059 over 
previous V2 Orion releases. However, in trying to find an issue with the Voice 
Recorder audio quality I have observed, consistently, that the "Monitor Audio" 
from the External Speaker output has a very different sound from the "Monitor 
Audio" that I hear from the from Headphone Jack. The audio seems to sound very 
much the same when I am listening to the "main receiver audio" out of the two 
outputs (External Speaker and Front Panel Headphone Audio Jack). Not sure why 
"main receiver audio" would sound the same and "Monitor Audio" would sound very 
different?

When listening to the "Monitor Audio" through the Front Headphone Jack it 
sounds clear (No SP) and crisp. When I listen to the "Monitor Audio" through 
the External Speaker output is sounds like there is a strong emphasis on the 
low frequencies and the audio starts to sound  slightly broken.  Have others 
using the Orion V2.059 observed a difference in "Monitor Audio" sound from the 
two outputs (Headphone Jack and External Speaker output)?

Barry I also observe that the SP is very aggressive, even at low settings, 
However, I have not gotten on-the-air comparisons of the audio with and without 
SP. If I listen to the "SP Monitor Audio" through the External Speaker output 
it gets distorted quickly. If I listen to the "SP Monitor Audio" through the 
Headphone Jack output it certainly gets "harsh sounding" but it doesn't seem to 
"distort" nearly as much. I would be interested in others comments on Speech 
Processing audio quality and at what settings they are using for SP?

Merle - W0EWM


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>