This may sound stupid, but did you check your setting for the RX EQ under
the Audio menu? It should be 0db for a flat response.
N5BLY
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of John T. Fleming
Sent: Friday, September 08, 2006 1:15 PM
To: TenTec Reflector
Subject: Re: [TenTec] Raspy audio in 2.059d
Rick,
I did all of the resets. No change. I did notice that I keep the bandwidth
at 2300 for SSB. If I increase the bandwidth to 2450, the 2.4 filter is not
in line and because of the increase of the "high" sounds; the noise is not
as noticeable. I will wait and see what other replies I receive. Thanks
for the suggestions.
73,
John
-----Original Message-----
From: Rick Williams [mailto:rick.williams@telus.net]
Sent: Friday, September 08, 2006 1:20 PM
To: W3GQJ@earthlink.net
Subject: RE: [TenTec] Raspy audio in 2.059d
John I have not noticed the raspy signal. I have, however, encountered
something similar on previous upgrades. The solution, for me, was:
1) Master Reset (Power on holding MAIN RX/TX)
2) Power off >> Power back on
3) RAM reset (Power on holding VFO B "LCK" button)
4) Power off >> Power back on
It worked for me.
73,
Rick
VE7TK
Website: http://www3.telus.net/ve7tk
---------------
Date: Fri, 8 Sep 2006 06:59:26 -0400
From: "John T. Fleming" <W3GQJ@earthlink.net>
Subject: [TenTec] Raspy audio in 2.059d
To: "TenTec Reflector" <tentec@contesting.com>
I notice a bit of raspy audio in the new version 2.059d software. I am
using the external Orion speaker which has a fair amount of bass response. I
can hear a bit of raspy noise like I have the NR turned on, even though it
shows off. Anyone else experience the same thing? Thanks.
73,
John
<\
----- \ 0 _
----------- _\\/\-%
______(_)===(_)____
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|