Counterpoise, absolutely, Needs to be the wave length, also can get a
artificual ground, use it with the counter poise. ( TT I think made one )
gutter, maybee but 'low' power, like 10 watts. Joints are good source for
rectification.
Watch out for TVI, a real headache with TV's, especially older ones.
Watch out for Phone Interference, might want to filter your lines but
really even that might not help.
Would try a vertical maybe mobile antenna with a gound plane, 3 wires the
length of the band needed, I've found that you can use ribbon cable. then
split up several wires leaving what looks like one wire but is actually
several different lengths of wire for the desired bands.
Speaking of which, have you thought about going mobile? much better
situation.
Tuner ' yes ' or better yet, base load the antenna with a coil.
Can try a high guage magnet wire strung around the outside, again low
power...
lots of ideas, but really is a matter of practicality and what you want to
do.
Best wishes,
Rich
K5SF
From: Dave Tipton <dave@lodave.org>
Reply-To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
To: tentec@contesting.com
Subject: [TenTec] Ok, Off Topic, but long time no talk to folks...
Date: Tue, 29 Aug 2006 12:10:18 -0700 (PDT)
I have found myself living in Southern California for the next 6 months.
Worse yet, in a 850 sq foot apartment. While this is not ALL bad, it does
create some real issues.
That said...
I'm contemplating running a sheet metal screw straight into the gutter
that runs out side of my balcony. It's about 20 feet tall, connected to a
30 foot wide section. An Inverted L sorta...
What would be the absolute best way to load this? I'm on the second
floor.. Can't put in a real ground system. Should I get a 35 foot spool of
wire and try to make a counterpoise by unrolling it? I can snake it around
my living room.
Ok guys, let's hear your suggestions.
Thanks,
Dave
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|