Bernard, i use LOGic8 and MixW. the connection to the Orion is simple plug
the serial cable into your computer or into a USB to serial adapter. you may
have to set your software to the COM port.
if you wish to use your software to send CW, you will need another serial
port or USB connection to a keying circuit of some simple sort.
the cable supplied with your Orion for the I/O Aux to computer sound card
does the digital mode your software specifies.
MixW's help file shows a two resistor, one diode, one transistor circuit
that keys CW.
otherwise there is only the Orion to set. the manual suggests starting
points for digital operation.
i have two Orions hooked to my computer. LOGic8 reads them both at the same
time. with the mouse i can set the active radio. i have separate CW keying
switches which can change in MixW by changing the COM port to be keyed.
digital modes need no other connectors.
the Orion was engineered for digital modes and needs no adapters of any kind
except to go from the ends of the I/O cable which have RCA plugs to 1/8"
plugs for the sound card.
73 jack ak7o
ich wuensche ich koennte alles auf Deutsch erklaren, aber mein Deutsch
reicht nicht!
----- Original Message -----
From: "Bernhard Hoidn" <bernhard.hoidn@onlinehome.de>
To: "TenTecForum" <tentec@contesting.com>
Sent: Friday, August 18, 2006 4:35 AM
Subject: [TenTec] PSK31 with Orion I V2
Hallo
can I use my Orion I V2 in PSK31 without an interface?
And if its possible, how is the connection between soundcard and TRX?
I use the Hamradio del Luxe/ PSK31 DeLuxe software.
Thanks for help
Bernhard
DL2RBB
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|