TenTec
[Top] [All Lists]

Re: [TenTec] Paragon II and SWR meter reading

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Paragon II and SWR meter reading
From: "Denton" <denton@oregontrail.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 9 Aug 2006 07:54:56 -0700
List-post: <mailto:tentec@contesting.com>
A subnote...if I connect my Mirage MP-1 line sensor directly in back of my Paragon II, then the swr readings on the MP-2 and rig will jive...even on 10 meters. ----- Original Message ----- From: "Denton" <denton@oregontrail.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, August 09, 2006 7:51 AM
Subject: Re: [TenTec] Paragon II and SWR meter reading


I notice the same on this end....Paragon II, 238B atu and MFJ-259B analyzer.
Also, my Mirage MP-2 wattmeters indicate a different power output reading
from the rig and atu if other than full power output from the Paragon II.

----- Original Message ----- From: <ARDUJENSKI@aol.com>
To: <tentec@contesting.com>
Sent: Wednesday, August 09, 2006 7:45 AM
Subject: [TenTec] Paragon II and SWR meter reading


I noticed that not in all cases will the meter (set to SWR) in the Paragon
II read exactly the same as that is the 238 ATU. By the way the 238 and
the
Paragon are connected by an 18 inch quality jumper (Belden 8214).

I found a discussion on the topic in the ARCHIVES at
_http://lists.contesting.com/archives//html/TenTec/2003-01/msg00663.html_
(http://lists.contesting.com/archives//html/TenTec/2003-01/msg00663.html)

Basically this section in short says to believe the meter in the rig.

SITUATION: I did notice that if I turn the  AGC button to OFF the  meter
will
match the ATU meter. (By the way I use a MFJ 249 Analyzer to find the
settings for the ATU but find in some cases it still needs to be tweeked
when I
push TUNE.)  Is this normal? I could not find anything in the manual that
even
mentions the AGC in conjunction with operation of the SWR/TUNE set  up.

Is this normal or do I have a problem I need to look into?

Thank you

Alan  KB7MBI
Woodinville, WA



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec





<Prev in Thread] Current Thread [Next in Thread>