The different settings you are using at 50 and 100 Hz track very close to
the difference I measured between the factory specifications and Orion II's
actual frequency response.
Ron N6AHA
----- Original Message -----
From: "Mark DeBord" <markinkpt@hotmail.com>
To: <tentec@contesting.com>
Sent: Saturday, August 05, 2006 1:05 PM
Subject: Re: [TenTec] settings for PR40, W2IHY, Orion I,and V2 firmware -
FYI
OK, I am almost using the same settings for V1 except for the 50 and 100.
For V1 I set them at 6 and 0. In V1 I have the mic gain set at 50 and the
TX
EQ is flat. I also run the bandwidth at 3000 and 50.
The Drake is set for 4k for initial testing but open it up to 6k as well.
With V2 I have also played with the following settings starting at 50 to
3200
12, 4, -4, -10, -4, 4, 14, and 16
This was not as pleasing to me, but does add a few more highs. To some, it
might sound ok.
Hope this helps.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|