I tried the setting below and it works
Larry Menzel <retire@means.net> wrote:
57600, N, 8, 1 Should do it.
Larry, N0XB
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Eugene Klingler
Sent: Wednesday, July 12, 2006 12:03 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] dxbase 2006/orion II
anyone know the baud rate, word length, parity & stop bits to use for the
orion II to be controlled by dxbase 2006....thanks gene klingler n8zx
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.1.394 / Virus Database: 268.10.1/389 - Release Date: 7/14/2006
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
Michael W. Elliott
THE INSIDE ADVANTAGE -
RETIREMENT - LEISURE, REST and ONLY ELECTRONIC MAIL PAYMENTS
Servant to Bridgett, Collin and all my Creditors
St. Louis County Missouri
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|