I was using Logic 7 with an Orion I and now am running Logic 8. I haven't
noticed a lag. If you can't figure out what is going on, give the program
author a call. He is very helpful and responsive.
Bob W2WG
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Duane A Calvin
Sent: Friday, June 16, 2006 9:09 PM
To: tentec@contesting.com
Subject: Re: [TenTec] Orion II Rig Response to Logic7 (Was: (no subject) )
Keith,
Check polling rate to see if changing that helps. I have run
both the Orion and Orion II with DX4WIN 7.0x and see only a slight delay
(on the order of 0.5 second) to changes in band or mode to when DX4WIN
picks it up live. I have my polling rate set to 500 ms. Hope this
helps.
73, Duane
On Fri, 16 Jun 2006 21:59:10 +0000 ac9s@mchsi.com writes:
> I received my new Orion II three days ago - it has been a blast so
> far, but I
> have one question. I am using Logic 7 for logging and have a
> problem with it
> reading band / mode data when I log a qso. Logic includes a
> primitive rig
> control window and that displays the Orion's frequency, mode, etc
> just fine
> and I can control the Orion from Logic without problem. I do note
> that the
> frequency display in Logic lags the Orion by a little. Logic does
> just fine
> with the Pro that I previously used and I am using the same serial
> card. Any
> thoughts?
>
> Thanks --
>
> Keith - AC9S
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
--------------------------------------
Duane Calvin, AC5AA
Austin, Texas
http://home.austin.rr.com/ac5aa
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|