Thanks carl...I really never got a chance to demo it due to school and
work
so I guess I will just purchase it.
As far as the responce using logic8. Do you really should work for them.
Personally, it's a fat program and costs too damn much!
On 4/16/06, Carl Moreschi <n4py@arrl.net> wrote:
If you run my N4PY Orion software in combination with MixW, all is well.
MixW can be configured to work with my software and the OII in complete
harmony.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Douglas Shock" <douglas.shock@gmail.com>
To: <TenTec@contesting.com>
Sent: Sunday, April 16, 2006 5:29 PM
Subject: [TenTec] Orion II and MixW cat issues
> Anyone experiancing issues with mixw and the Orion II performance when
> servicing interupts and using the cat interface from MixW?
>
> The only speed I can get anything to work at is 57600, but at this baud
> rate, the perfornace of the Orion II sweep is at a standstill and I
> have
to
> push buttons 3 to 4 times to get the Orion II to respond.
>
> When I change bands from within MiXw I can hear the radio change but
> the
> freq. readout doesn;t change.
>
> Any Ideas?
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec