Unless it actually has a failure (something broke)
I would strongly reccomend leaving it alone.
There is a reason for the cliche "If it ain't broke, don't fix it"
If it was an old tube rig built in 1946, then perhaps it may need some
touching up.
But an Omni 6 plus..built in 1999 or so ..should be the same as new...unless
someone already mucked with it.
....Dave
----- Original Message -----
From: "Lew" <ljl160@verizon.net>
To: <tentec@contesting.com>
Sent: Friday, April 14, 2006 9:52 AM
Subject: [TenTec] Alignment tools for Omni 6 Plus
I am going to check alignments on my Omni 6 Plus. A tech friend is helping
so before I take the rig over to him, does anyone know what alignment
tools I need? type and sizes etc?? Covers have not been off this awesome
rig!! Thanks-73-Lew K1NDV
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|