TenTec
[Top] [All Lists]

Re: [TenTec] Orion Question

To: "Carl Moreschi" <n4py@arrl.net>,"Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion Question
From: "Don and Diana Cunningham" <wb5hak@duracom.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 30 Mar 2006 10:07:31 -0600
List-post: <mailto:tentec@contesting.com>
Carl,
Thanks for getting this back to at least the original topic!!  I'll refrain 
from posting any more questions, just call Ten Tec repair, as the questions 
seldom get answered, just the threads distorted.  I guess the answer to my 
original question is, "no, there isn't a source of voltage from the Orion, 
somewhere between 3 and 15VDC, on during transmit only, that one can use". 
Gee, that would have been simple and not wasted so much time, hi.
73,
Don, WB5HAK
----- Original Message ----- 
From: "Carl Moreschi" <n4py@arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, March 30, 2006 10:01 AM
Subject: Re: [TenTec] Orion Question


> The biggest difference between using a relay and a transistor is the time 
> it
> takes to do the switch.  A transistor will switch in a few microseconds. 
> A
> relay will take in the order of 10 milliseconds to do the switch.  It all
> depends on what you are trying to do with this if the relay is fast enough
> or not.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
> ----- Original Message ----- 
> From: "Grant Youngman" <nq5t@comcast.net>
> To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
> Sent: Thursday, March 30, 2006 10:44 AM
> Subject: Re: [TenTec] Orion Question
>
>
>> > Grant, wouldn't a simple 12vdc relay work in this case?  Why
>> > would I need a transistor?  OR is it because the logic is
>> > reversed?  (in that case, use the opposite N.O. poles)
>>
>> I think that would work just fine.  Just run +12 (or +5 or whatever)
> through
>> a current limiting resistor in series with the relay coil and connect the
>> other end of the coil to a TX OUT line.  That will energize the relay 
>> when
>> the Orion goes into transmit and pulls the TX OUT line low.  And a N.O.
>> contact can switch the voltage you want to control.
>>
>> Grant/NQ5T
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>