RE: 566 Manual Part #74410 Items (44) Main AF Encoder and (45) sub AF
Encoder as they relate to Items (74) Line Out and (80) Aux I/O Pin 4
Was reported to ditsnbits@tentec.com and email received by Ten-Tec Software
Support 3/25/2006.
RE: 566 Manual Part #74410 Items (44) Main AF Encoder and (45) sub AF
Encoder as they relate to Items (74) Line Out and (80) Aux I/O Pin 4
The internal speaker and (78) ExtSpkr are working properly controlled by
(44) and (45). However, Muting and Volume Control (44) and (45) in the
latest firmware (v2.032) affect the Line Out as well as the speaker making
it necessary to listen to the screeching when using the rig for digital
(PSK31).
Line Out (Items (74) Line Out and (80) Aux I/O Pin 4) needs to be at a
continuous level as set by Menu/Other/LineOutSrc and
Menu/Other/LineOutLevel.
This appeared to work as it should on the Initial Production Release
Version 2.025, but I'm not sure when it changed.
Alan Hodel, KW9T
Newburg, Maryland
----- Original Message -----
From: <K4IA@aol.com>
To: <tentec@contesting.com>
Cc: <ditsnbits@tentec.com>
Sent: Monday, March 27, 2006 12:27 AM
Subject: [TenTec] Orion Aux Audio output
>I have been trying to get back into digital modes and notice that the audio
> output from the AUX I/O connector pin 4 seems to depend on the volume
> control
> instead of being a line out as described in the manual and as it operated
> prior to ver 2.
>
> This is maddening because it means you have to turn up the volume and
> listen
> to the warbling. Before you could turn down the volume and just watch
> the
> screen.
>
> Anyone else notice this?
>
> K4ia "Buck"
> Fredericksburg, Virginia USA
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|