TenTec
[Top] [All Lists]

Re: [TenTec] Pegasus / Softrock 5

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Pegasus / Softrock 5
From: Jerry Schantz <jschantz@franklinisp.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 16 Mar 2006 21:05:45 -0500
List-post: <mailto:tentec@contesting.com>
Mark Erbaugh wrote:

>The Softrock 5 is a kit to build a QSD (quadrature sampling detector). The I 
>and Q output can be fed to the left and right audio inputs of a computer 
>soundcard where software can decode the signals received. This is similar to 
>the receiver in the Flex-Radio SDR-1000.
>
>The difference is that with the Softrock 5, the frequency source is a fixed 
>crystal rather than a variable frequency (DDS in the SDR-1000).  However, the 
>Softrock 5 has the QSD hardware on one board and the crystal and bandpass 
>filtering on a plug in board. It's actually designed that the crystal / BPF 
>board could be replaced with different hardware, including a VFO to allow 
>tuning over a wider range (the current tuning range is limited to the sampling 
>frequency of the soundcard).
>
>Has anyone considered using the Pegasus as the frequency source and BPF.  
>Ideally, you could mount the Softrock 5 QSD board inside the Pegasus and pick 
>up the frequency source and post BPF signal from there. 
>
>It already is possible to pick up an approximately 12 kHz IF signal from 
>inside the Pegasus and feed it to a computer sound card, but I'm thinking a 
>QSD signal would give you both I and Q signals to work with and would probably 
>have better IMD performance.
>
>For more info on the Softrock 5, check out www.hamsdr.com
>
>73,
>Mark, N8ME
>
>P.S. The Softrock 5 is based in the Softrock 40. The Softrock 40 kit had the 
>frequency source and BPF on the same board as the QSD.
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>  
>
Not certain about the Pegasus, but I believe several are working with 
different inputs to the QSD board. There is a Yahoo group specifically 
for Softrock users. LOTS of information here.
Really a pretty cool little receiver if you computer has the horsepower 
to run it.
I have been thinking about one of the TT direct conversion kits as the 
'receiver'  then running  thru the QSD board, just have not had the time 
yet...so many toys so little time.

73
Jerry  W9JJS
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>