On my 756pro, you can tune the sweep signals by watching the display move as
you tune from the radio. It is interesting to note that if you tune the
Orion II with my software, the sweep does not stop as you tune and you can
watch the screen and tune it in.
But what I find the easiest to do is to look at the sweep. If I see a
signal up 7 khz, I just mentally add 7 khz to the display and turn to that
frequency. This is really very easy to do.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Bob" <k2zc@rtort.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, March 11, 2006 10:26 PM
Subject: Re: [TenTec] Sweep on OII
> Grant Youngman wrote:
>
> >
> > I think the
> >reason it can't handle "continuous" operation (even with the newer CPU's)
is
> >that there is (as yet) no independent IF/DSP acting as the spectrum
analyser
> >for the sweep display. If you look at some other radios (going back to
my
> >old IC-781, and including the current crop of $10-15K things), they have
> >what essentially amounts to 3rd receiver (or at least IF strip and
> >associated stuff) handling that function.
> >
> >
> >
> I think the 756ProII has this capabilty, not sure if it has a third
> receiver though.
>
> This thread surprsed me. I thought the fish finder on the O2 was better
> then the Icom 756Pro series. Guess I will find out when I get my O2 next
> month.
>
> Bob - N6RI
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|