Installed 2.055 last night. The AM problem that has been frequently mentioned
(headphones shut down after keying rig if the secondary receiver is in AM mode)
appears. It must be "standard" in the V2 releases thus far.
Mic gain must be set very low (setting is "6" with my old, old Heathkit
Electrovoice 638), but the audio glitches that arrived with 2.054 seem to be
gone. Speech processing still very sensitive; setting "2" seems best here. Aux
audio imput (from RigExpert) seems more stable than with 2.054 (mine is set on
"20").
My SWR indications have always been somewhat erratic; I assume this is probably
a timing issue with a busy CPU.
I can understand that going to completely new "base" code in V2 was a major
move. The base seems stable now and perhaps the various processing problems in
the audio chain(s) will be fixed in the near future.
Everyone has suggestions: my highest priority suggestion would be to allow CW
keying while in SSB/AM modes. (It would make amplifier tuning easier.)
Bill
W2WO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|