Yes...we've had quite a string on that involving 2.031 on the O2. The new
firmware made what may have been a latent problem show up. The max voltage
you're supposed to use with the QSK TX Out is 15, supplied by the amp. The
TX Out simply pulls low. TT's Titan 425 uses 24 Volts on that circuit, and
for some reason, something that changed on the new O2 upload made the radio
not want to work right with it. I may build an external switch using a
couple of NPN's one driving the other if I get the time, unless I hear a
better solution. I have reported my findings to TT.
Ron
N6AHA
----- Original Message -----
From: "Rick Williams" <rick.williams@telus.net>
To: <tentec@contesting.com>
Sent: Saturday, March 04, 2006 8:26 PM
Subject: [TenTec] Orion 2.055 problem?
> On 2 separate occasions this weekend I've had the receiver in my Orion
> lose
> sensitivity when working split and using the amplifier. Tonight I was on
> 40
> metres SSB listening 7.094 and transmitting 7.184 MHz. I called KH7X and
> when the receiver came back the signal had dropped. It had dropped
> significantly! It came right back up as soon as I turned off the
> amplifier.
>
> I cycled the amplifier on and off but the problem remained. I cycled the
> Orion and presto the amplifier no longer degraded the signal. I
> transmitted
> split again and could not duplicate the problem?
>
> Both receivers were in LSB and other parameters were as they had been for
> several hours. The amp is a Ten-Tec Hercules II and the Orion is running
> 2.055 with keying loop #1 is on.
>
> Has anyone else encountered this? Any thoughts?
>
>
> 73,
>
> Rick
> VE7TK
>
> Website: http://www3.telus.net/ve7tk
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|