W2RBA:
>Well, it too good to last. I have a problem, albeit a minor one, with
the latest version of the software and my Orion I -- the headphone jack
quit! I loaded it last night and everything seemed quite good; today I
was testing it some more and at one point reached for my headphones,
plugged 'em in and heard....nothing. Well, not exactly nothing, at full
volume the merest hint of cw could faintly be heard (distorted, by the
way). The same headphones work fine with any other of my radios
including a K2, a K1, a KX1 and various Ten-Tecs (Triton IV, Corsair I,
Delta). Anyone else notice this problem? Anyone else have a solution?
Identical problem reported by NT1A on the Yahoo list:
http://groups.yahoo.com/group/orion565/message/1265
73, Bill W4ZV
Everything was working pretty well with this release, then my
headphones suddenly cut out when I was sending some CW. I turned the
rig off then on again and the same thing happened.
I had been chatting on CW all last night with no problems. This
morning I turn the rig on, send a couple CQ's and no headphones.
There is still audio on the internal speaker, and turning the rig on
and off brings back the headphones.... until I send and then they cut
out again.
Anyone else observe this? Possible fixes?
I did do a master reset after installing 2.055.
Thanks!
-Nick NT1A
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|