TenTec
[Top] [All Lists]

Re: [TenTec] Hercules II anomaly?

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Hercules II anomaly?
From: "Mike Brown" <k9mi@sbcglobal.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 7 Feb 2006 14:35:09 -0000
List-post: <mailto:tentec@contesting.com>
Rick, is the 20m antenna closer to the shack then the other antennas?

73, Mike K9MI


----- Original Message ----- From: "Rick Williams" <rick.williams@telus.net>
To: <tentec@contesting.com>
Sent: Monday, February 06, 2006 5:14 PM
Subject: [TenTec] Hercules II anomaly?


Well I have a new one?  I have recently noticed a discrepancy between the
SWR measured by my Orion (internal tuner disabled) and by my LDG DWM-4
wattmeter.  I've checked the LDG meter with my Bird and all seems okay.
So
I've tried to isolate the problem.

The problem disappears when I take the Hercules II out of the circuit. My
problem occurs on 20 metres with the rig showing an SWR of about 2.5 : 1
and
the external meter about 1.4 : 1. When I remove the Herc input and output
coaxes from the amp and connect them together with an Amphenol barrel
connector both meters read an SWR of about 1.4 : 1?  With power, control
and
keying loop cables removed the problem still exists.

Of course all of this is happening with the Herc off and the only
components
I can see in the circuit are the input relay - K1 and the vacuum relay.
Both are unenergized and normally closed with a DC resistance of less than
0.5 ohms.  I have checked 80 metres, 17 metres and 15 metres and the
problem
does not occur there.  It seems confined to 20?

Thoughts appreciated.  Thanks.

73,

Rick
VE7TK

Website:  http://www3.telus.net/ve7tk


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




<Prev in Thread] Current Thread [Next in Thread>