TenTec
[Top] [All Lists]

Re: [TenTec] Help with Orion I

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Help with Orion I
From: "Robert Higgins" <rwhiggins@bellsouth.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 21 Jan 2006 12:17:02 -0500
List-post: <mailto:tentec@contesting.com>

The reciver isn't on mute by any chance? Are the correct antenna/vfo selections made?

 73
 Bob K4LW


 >I just acquired an Orion I from a friend who only used it about 6 hours
 > before packing it up for a move 15 months ago. He never got around to
> unpacking it after the move and I talked him into selling it to me. When I > got it home and turned it on, I heard some static from the speaker for a few > seconds and then nothing. Nothing that I have been able to do will produce > any noise from the speaker and there is no movement in the analogue S meter > either. The Display works fine and all the controls appear to work, except > the AF controls, although I do see the audio level indicators on the display
 > move across the screen as I turn the audio up. I do get readings on the
> Sweep display like it is receiving signals. But they are not getting to the
 > S-Meter or the speaker. I did a Master Reset but no help. I have been
> through every menu item. All check out. I have not tried to transmit yet. > I have the speaker turned on in the Audio Menu. I a VFO and Antenna assigned
 > to the Main or Sub Receiver as required.
> I have been through the manual three times. I am pretty sure that I have all
 > the Menue Items and Controls set correctly.
 > I took the top off and checked  the filters. They are all in place. All
 > cables look plugged in correctly.
> The only thing that I have found in the manual that might even come close to > causing a problem like I have described is a reference to the need to use a > Stereo Plug if one uses Headphones. Appearenty if one uses a Mono Plug, it
 > can cause damage to the radio.  I don't use ear phones and did not plug
> anything into this jack. So I know that is not the problem. I am using the
 > internal speaker.
 > Any ideas from the group? I am still hoping that it is operator problem
 > rather than problems with the radio.
 > Thanks. Charlie Hugg, K5MBX
 > ________________________________
 > See my Signal/One, Collins & Drake
 > Photo Galleries and my Hallicrafters
 > Virtual Museum at http://hug-a-bug.com
 >
 > _______________________________________________
 > TenTec mailing list
 > TenTec@contesting.com
 > http://lists.contesting.com/mailman/listinfo/tentec


--------------------------------------------------------------------------------



<Prev in Thread] Current Thread [Next in Thread>