Re: [TenTec] 2.028 is out - error message

["Joseph A. & Ruth O. Ryan" <ablee@bellsouth.net>]

So, its downloaded and installed....Carl, have you figured out what
they, indeed, update?
Or is it too soon to tell?
73', Joe, KX4JR

At 10:57 PM 01/09/2006, you wrote:
> When your flash utility first starts, select "Settings".  In here you will
> be able to define which comport the Orion II is connected to.  Once you have
> done this, then power off your OII.  Then hold down the "recall" button and
> power on.  Do not release the button until the OII says "Flash update mode".
> Once the OII is in flash update mode, click "Process" in the flash update
> utility.  This should get you going.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635