TenTec
[Top] [All Lists]

Re: [TenTec] D 104 and Argonaut V

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] D 104 and Argonaut V
From: "Dave Edwards" <kd2e@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 27 Dec 2005 13:02:07 -0500
List-post: <mailto:tentec@contesting.com>
Others will confirm this, but I think you have a D-104 that someone has been in to!!
I would rip out anybody's goofy brilliant mods, and start from scratch.
The switch and extra two wire cable are not standard.
....Dave
----- Original Message ----- From: "William" <wjsmorrison@shaw.ca>
To: <tentec@contesting.com>
Sent: Tuesday, December 27, 2005 12:56 PM
Subject: [TenTec] D 104 and Argonaut V


My son gave me a nice D 104 Silver Eagle, the one with the pre amp-I am
guessing since it has the standard mic cable, a two wire cable which I
assume is for powering the amp and a small switch on one side.

I would like to use this with my Argonaut V and need to know what voltage
should be supplied and any recommendations on setting the gain via the small
pot in the base.

Thanks,

Bill
VE7BER
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


<Prev in Thread] Current Thread [Next in Thread>