Barry, I recall "hearing" that the new filters are a different size than the
old ones. If that is correct, that would mean they are not interchangeable.
73
Rick
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Barry Gross
Sent: Tuesday, December 27, 2005 8:31 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] ORION Inrad 600 CPS Roofing filter (NIB) Available
On 12/27/05, Neal Campbell <nealk3nc@peoplepc.com> wrote:
>
> I understood the roofing filters were different in the O2!
>
Many Orion 1 cw enthusiasts are using the Inrad 762 filter (600hz 4-pole) in
the Orion 1's 1000hz slot.
Again, is there info indicating that the Inrad 762 won't work/fit in the
Orion 2 600hz slot? Perhaps the pin config has changed for the O2 filter
slots?
73, Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|