I placed a small piece of paper between the relay contacts...just lifted off
the case ...worked fine, Steve
----- Original Message -----
From: "John Holliman" <w5ot@aol.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, December 16, 2005 4:00 PM
Subject: Re: [TenTec] OMNI-5 clicking
I did number 2 except I installed a micropswitch on the back panel so
the relay could be enabled when needed.
Roy Koeppe wrote on 12/15/2005, 11:22 PM:
> Asked,
>
> "When I send CW, I hear a relay clicking. I'm guessing it has something
> to do with non-QSK switching for a linear (which I don't have). Is it
> something I can disable to quiet the rig?"
>
> - Keith -
> _______________________________________________
>
> Keith,
>
> #1. Drive a toothpick between the relay armature and its core. --OR--
>
> #2. Lift one end of the relay-driver transistor's base connection. It
> can be re-soldered if ever needed.
>
> 73, Roy K6XK Iowa
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|