As to using 572B's in the Centaur 411, there is no advantage unless the
power supply is adequately beefed up to take advantage of the increased
dissipation and thus higher output rating.
73
Bob, K4TAX
----- Original Message -----
From: "Ken Brown" <ken.d.brown@verizon.net>
To: <tentec@contesting.com>
Sent: Saturday, December 10, 2005 5:34 PM
Subject: [TenTec] Ten-Tec 811A or 572B amplifiers?
> Looking at the Unofficial and official Ten-Tec web sites, I see only one
> amplifier by Ten-Tec that uses 811A tubes. This is the Centaur 411 which
> uses three 811As. Has Ten-Tec never made an amplifer that used two 811As
> or four 811As? How about 572Bs? Has Ten-Tec ever made an amplifier that
> used 572Bs? Can 572Bs be used in the Centaur 411?
>
> DE N6KB
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|