Mark, I don't know about the Omni V, but the Paragor (one) that I have has
the RS232 option installed, and the manual says it's an option. I have the
old Basic program from TT, but these new computers are too fast to run the
original Base program for the Paragon. Thanks for the answer. Bruce W1GBS
PS If you should come accross a modern program, let me know....
----- Original Message -----
From: "Mark Choate" <aa0yy@sbcglobal.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, December 08, 2005 6:11 PM
Subject: Re: [TenTec] RS-232 Control codes for PARAGON
Bruce are you sure that the Paragon is even capable of being rig
controlled?
I have an Omni V and had no luck when tried persuing rig control for it.
Educate me pse.
Mark
----- Original Message -----
From: "Bruce Lanning" <blanning@acadia.net>
To: <TenTec@contesting.com>
Sent: Thursday, December 08, 2005 4:58 PM
Subject: [TenTec] RS-232 Control codes for PARAGON
Does anyone have a copy of the PARAGON 585 control codes for the RS-232
interface option. I would be happy to pay any costs involved. Bruce W1GBS
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|