Re: [TenTec] Airpax circuit breakers

["RLW" <weave2@sbcglobal.net>]

Here is what I found as the best place for the airpax breakers.  They have 
one at 20 AMPs and a lower one for Argosy type rigs.  TT service referred me 
to them.
Wards Electronics
Ft. Lauderdale, FL
800-545-9273

I use for TT and other rigs as a just in case precaution. Fast acting is a 
requirement per TT.  Good Luck,
Rick K8RLW

----- Original Message ----- 
From: "Mike Hyder -N4NT-" <n4nt_m_o_hyder@charter.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, November 28, 2005 10:50 AM
Subject: Re: [TenTec] Airpax circuit breakers


> Check here:
>
> http://www.pocosales.com/ProductSpecifications/ProductSpecifications.pl?Manufacturer=Airpax&Setup=SpecFrames&Series=SNAPAK
>
> The Ten-Tec supplied ones had a paddle handle.  I believe the 1140 was 
> rated
> at 18 amps.  Looking at the above link, it appears 17.5 amps is closest to
> that.  I've seen discussion before that the "Fast acting" ones were fast
> enough and "Instant" was overkill.  I believe without knowing that "Fast" 
> is
> what Ten-Tec supplied.
>
> I'd work this out to be a   T11-1-175 or with the Omni VI, you might need
> the final 3 digits 200 for 20 amps.
>
> For use in an automobile, I'd suggest a double-pole breaker.
>
> 73, Mike N4NT
>
> ----- Original Message ----- 
> From: "Lawrence Matheson" <wa4bhk@bellsouth.net>
> To: <tentec@contesting.com>
> Sent: Monday, November 28, 2005 10:16 AM
> Subject: [TenTec] Airpax circuit breakers
>
>
> Getting ready to order a couple of circuit breakers from Poco Sales for my
> two Omni VIs.  The Ten Tec part number is 1140.  Does anyone know what
> Airpax part number this is?  Thanks,
>
> Lawrence,  WA4BHK
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec