I think the skirt adjustment was a later offering on the Omni VI, perhaps,
and is sometimes retrofitted to the Paragon. Still, the drag on the main
tuning knob is adjustable and controlled by some copper fingers that press
against the smooth area of the panel behind the dial. You vary the drag by
how far from the panel the knob is positioned. Remove the knob as described
before (and put a drop of light lubricant on the shaft while it is off) and
them mount it at the position that gives the feel you are seeking.
=Vic=
WA4THR
----------------------------------------------------------------------------
----------------------
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Paragon
From: "Charles Nagel" <cnagel@sbcglobal.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 30 Oct 2005 14:57:43 -0600
List-post: <mailto:tentec@contesting.com>
Lee,
Unfortunately my knob isn't the configuration you describe below in that the
skirt doesn't turn. It's anchored (or molded at three points) to the inside
surface of the knob and is held on to the 1/4 inch shaft by one set screw.
It's possible I don't have the latest version of the knob assembly on this
unit which I purchased as reconditioned equipment from TT recently.
It was worth a try. Still a good radio.
Charles, K0CW
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|