TenTec items For Sale:
TenTec 1202 combination HF and VHF wattmeter
This wattmeter will permit a ham to connect both an HF rig
and a VHF rig to the wattmeter at the same time. A switch
on the front of the meter selects whether HF or VHF is being
measured. HF covers 1.8 to 54 MHz, so it includes 6 meters
as well as HF. VHF is really the 2 meter band, covering 140
to 150 MHz. Full scale reading is 200 W or 20 W. It can be
powered from an internal 9 V battery, or from external 9 to
14 volts DC. Of course one can measure SWR as well as
forward and reflected power.
This particular unit looks very close to new. I can not find a
scratch on it. Of course it works fine also. Paper work is
included for $60.
TenTec 546 Omni D, series B, HF CW / SSB xcvr.
All solid state, with up to 100 W output. The ALC can
also be turned back with a front panel control for QRP
operation. Covers 160 through 10 meters. This one also
includes transmit and receive on the 10 MHz band. Full
QSK on CW, and a fantastic receiver. Terrific audio
quality on SSB also. Built in audio CW filter. Digital
read out. This one is in very nice shape, both electrically
and cosmetically. With manual for $235.
TenTec 218, 1800 Hz crystal filter
This crystal filter is for the 9 MHz IF in TenTec rigs.
This includes the Omnis and Argosy, and maybe others.
It can also be used as a roofing filter in the Orion. It is in
good condition, and includes paper work with it for $69.
TenTec 255 Deluxe Power Supply
Matches the early Omni series, and includes speaker,
ammeter, and trim ring. Dual pass transistors similar
to the heavy duty 280 power supply. It is good for 20
amps at 13 V DC, and includes over voltage protection.
This one looks fine, and works the same.
With manual for $ 135.
TenTec 252 MO power supply, 20 amp, 13 V DC supply.
Has ammeter on front. Matches the Omni series, but of
course can be used with any rig needing a 20 amp
power supply, which includes most TenTec rigs. This unit
has the optional over voltage protection unit mounted
inside. It is in great condition, with manual for $ 110.
Power cable for Hercules 444 linear amplifier
This is the heavy cable that goes from the power
supply to the amp. It has a heavy duty 9 pin molex
type connector on both ends, and either #12 or #14
wire, and is about 6 feet long. It is in good shape. $18
Prices do not include shipping from Florida.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK@speakeasy.net or W8EK@arrl.net
Voice Phone (352) 732-8400
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|