Hi, Barry-
I was looking on 34 but couldn't get it to do the job. The VFO A/B
selection lets you swap the contents of A and B--and you could tune A and
then swap back, and the VFO B enter lets you type freqs into VFO B--but when
you turn the knob it is A which moves. I may be hallucinating, but I am
pretty sure I was able to make the remote pod knob tune B in the past. I
would like to do so to search for the station being worked under split
conditions. The flip flip will work, but I'd rather do something more
direct. If you figure it out, please give me a shout.
Bob W2WG
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Barry Gross
Sent: Wednesday, October 05, 2005 11:23 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Orion Remote Pod
>
>
> On 10/5/05, ROBERT CARROLL <w2wg@comcast.net> wrote:
> >
> > Could someone remind me how to get the Orion remote VFO knob to tune VFO
> > B
> > instead of VFO A? My Orion is just back in the shack after a move, and I
> > forgotten.
>
>
> Off the top of my head at work, try the Other menu or RTM
>
> Barry N1EU
There it is on p34 of the manual - bottom of the Other menu "Remote Pod Enc"
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|