TenTec
[Top] [All Lists]

[TenTec] Transmission line loss due to SWR

To: tentec@contesting.com
Subject: [TenTec] Transmission line loss due to SWR
From: "Rob Atkinson, K5UJ" <k5uj@hotmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 05 Oct 2005 14:47:19 +0000
List-post: <mailto:tentec@contesting.com>
One of the reasons why I chose to use open wire feedline for one of my 
antennas, was that I could not get it big enough to use on the lowest 
frequency I wanted to operate on with it, and I read in the QST article, The 
Lure of the Ladder Line, that the loss with coaxial feed goes way up when 
the load starts getting small with respect to wavelength, say around 1/3 w.  
  With a balanced parallel wire feed the loss goes up also, but not nearly 
as much.     There is a limit to what you can get away with though--my loop 
is 1 w. a bit up above 4 mhz and I can use it anywhere on 80 m. but it would 
be a poor antenna on 160.

rob/k5uj

_________________________________________________________________
On the road to retirement? Check out MSN Life Events for advice on how to 
get there! http://lifeevents.msn.com/category.aspx?cid=Retirement

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Transmission line loss due to SWR, Rob Atkinson, K5UJ <=