Excellent application for open wire line.
73
Bob, K4TAX
----- Original Message -----
From: "Lee Crocker" <w9oy@yahoo.com>
To: <tentec@contesting.com>
Sent: Tuesday, October 04, 2005 7:41 AM
Subject: [TenTec] Openwire fed differently
> For completeness of this thread, I checked with a
> friend of mine who runs 1000ft of openwire line from
> his house out to his antenna farm. The line is
> terminated by broad band trandformers at each end. He
> uses this as a low loss condiut rather than trying to
> run a thousand feet of coax with its inherent loss,
> and he uses it to feed his beams etc. He does not
> twist, and notices no problem with balance. The line
> has very good isolation.
>
> Just another data point for the hopper
>
> 73 W9OY
>
>
>
>
> ______________________________________________________
> Yahoo! for Good
> Donate to the Hurricane Katrina relief effort.
> http://store.yahoo.com/redcross-donate3/
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|