TenTec
[Top] [All Lists]

Re: [TenTec] Argonaut V new user

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Argonaut V new user
From: "Carl Moreschi" <n4py@arrl.net>
Reply-to: Carl Moreschi <n4py@arrl.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 2 Oct 2005 12:59:13 -0400
List-post: <mailto:tentec@contesting.com>
It sounds like you may have a bad low pass filter relay.

Carl Moreschi N4PY
Franklinton, North Carolina
n4py@earthlink.net
----- Original Message -----
From: "Bob Ragain" <rragain@att.net>
To: <tentec@contesting.com>
Sent: Sunday, October 02, 2005 2:29 PM
Subject: [TenTec] Argonaut V new user


> Hi everyone,
>
> I just bought an Argo V at the fest on Saturday.  My first contacts were a
> couple of Brazilian stations, :-)  This is a wonderful little radio!
>
> But, I'm having what's probably an operator error.  The receiver goes dead
> below 1800 kHz.  I hear 160m just fine, and I even hear a second harmonic
> of a 1400 kHz BC station on 2800 kHz, but when I tune below 1800 kHz I
hear
> a click, and there are no broadcast stations heard from 1800 kHz down to
> 500 kHz.
>
> I have done a reset, no help.
>
> Thanks,
>
> Bob  WB4ETT
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>