| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] open wire feed line |
| From: | Barry Gross <barry.n1eu@gmail.com> |
| Reply-to: | Barry Gross <barry.n1eu@gmail.com>,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 30 Sep 2005 20:26:33 +0000 |
| List-post: | <mailto:tentec@contesting.com> |
On 9/30/05, Mike Brown <k9mi@sbcglobal.net> wrote: > > I use stranded, the solid has a tendency to break > I use solid copperweld. In my case, the stranded has a tendency to break. DavisRF and the wireman are good sources. I've got two 580ft Beverages made of this stuff. 73, Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] open wire feed line, NJ0IP |
|---|---|
| Next by Date: | Re: [TenTec] open wire feed line, Robert & Linda McGraw K4TAX |
| Previous by Thread: | Re: [TenTec] open wire feed line, Stuart Rohre |
| Next by Thread: | Re: [TenTec] open wire feed line, Bob Cunnings |
| Indexes: | [Date] [Thread] [Top] [All Lists] |