Tommy used the PROC button to control the INRAD roofing filter mod. But
I occasionally use the speech processor and would hate to disable it.
Has anyone successfully used the FM or VOICE buttons to enable the INRAD
roofing filter? The FM button is the logical choice, since FM would not
be used after the mod.
Thanks!
Jim N4AL
Tommy wrote:
.....
I have my roofing filters set up a little different from the Inrad
instructions. The Inrad instructions allow you to turn the roofing
filter ON or OFF by using the N-1 or N-2 filter selection buttons on
the 6+. Since all that is needed to switch the filter in or out is
positive voltage, I choose to use the PROCessor button on the front
panel to do the switching. This way, you only have to run a single
wire. The Inrad method requires cutting wires, splicing, etc., but
their method probably works fine.
73,
Tommy - W4BQF
|