That's a great idea, but is it really 'simple'? And would it still be
affordable to the average ham? It would be simple if you could make
each module completely independent of all other modules. And if you
could design the modules so that when you replace one, you would not
require some sort of alignment process. I think more and more today,
hams have less and less test equipment, however the approach by
Eletech sure seem to be working out pretty good.
Might work but of course it would have to be very carefully planned out.
Tommy - W4BQF
It's simple. Buy or build radios that are sufficiently
modular such that the pieces that do become quickly obsolete
can be easily changed out and upgraded. And the pieces and
parts that don't really change that much can stay around
through the various HW upgrades.
This approach will work because things like band pass and low
pass filtering, RX preamps and mixers, TX amplifier chains
etc. haven't changed appreciably in 10 or more years. Those
kinds of parts and circuits built back then (or even before)
still perform as well as they always have. And new designs
today of these mature components are minimally different in
terms of performance. However the DSP and ADC parts of some
of those radios built in the early 90's are very obsolete
today. Even those DSP-ish radios from 5 years ago are really
rather obsolete DSP-wise today; their analog circuitry for
the most part is not. A radio designed such that you can
simply swap out those rapidly changing technology pieces and
parts out is a very compelling design approach to take. The
"DSP IF" experiments to a Corsair II that I have done are
essentially a variation of this concept.
Duane
N9DG
____________________________________________________
Start your day with Yahoo! - make it your home page
http://www.yahoo.com/r/hs
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|