No tripping but low current out and the rig ofcourse starts to pull down at
low drive output. tnx-Lew
-------Original Message-------
From: Phil Chambley, Sr.
Date: 07/09/05 18:53:10
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] 280 PS question
Do you mean it trips at 4 amps?
VFO Stabilizers and PEP adapters for wattmeters...Check out
http://home.comcast.net/~k4dpk
----- Original Message -----
From: "Lew" <ljl160@netzero.net>
To: <tentec@contesting.com>
Sent: Saturday, July 09, 2005 6:31 PM
Subject: [TenTec] 280 PS question
> I replaced bad finals in my 280 PS and now only get 3 or 4 amps. I used
2n3055s I had on hand. Is that the problem or do I have something else going
on. Thanks-73-Lew K1NDV
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|