On Mon, 13 Jun 2005 14:03:57 -0500 "Grant Youngman" <nq5t@comcast.net>
writes:
> > On my Orion, using 1.372, pushing the NR button doesn't
> > always turn NR on or off. I can do so reliably with Ham
> > Radio Deluxe control software and that is how I do it. I
> > also notice that there is often a lag in adjusting Cut or PBT
> > or even AGC at times.
>
>
> That's really strange. Never observed that on 1.372. Do you have your
> control software sitting active on the async port, when this happens?
The
> only time I've ever had a problem like this is in the dim past when I
tried
> to run both N4PY and the Orion front panel at the same time.
>
. . . snip . . .
I have seen this a number of times. With 1.372, often a single push of a
button does not do what it is supposed to do. I can't recall all the
ones I've seen it happen with, but NR, NB, AN, and I believe RFGAIN. The
visual indicator says it has changed, but in fact it does not. It does
not occur with earlier levels of FW. This was reported early in the life
of 1.372 here on the reflector by several people.
73, Duane
--------------------------------------
Duane Calvin, AC5AA
Austin, Texas
http://home.austin.rr.com/ac5aa
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|