My N4PY program sets the comport speed to 57600 baud. This is the only
speed the Pegasus runs at and the program would not work unless this was the
set speed. When you look at system information for comports, you are only
seeing the default settings if the program had not actually set them.
73,
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "J. Reed" <jhreed@chilitech.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, June 07, 2005 6:23 AM
Subject: Re: [TenTec] Com 1 speed?
> N4PY Pegasus, TenTec 550 /computer program:
>
> Dell Dimension 3000 @ 2.4ghz, 512mb ram, etc.
>
> Ran 'system' information while 'Peg 550' was on.
>
> Feeling like the com-1 speed is too low, (9600 baud,
> 8 bits, 1 stop). Can I boot the port speed up to 57,600
> or is it 'set' by the your program? Thanks, Jim Reed.
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|