I recommend that the TEN TEC reflector be shut down.
Jim Dunbar
K4PV
Senior Electrical Engineer
Advanced Programs Division
AeroSpace Integration Corporation
Crestview, Florida
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Jerry Volpe
Sent: Tuesday, May 31, 2005 9:08 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] ORION, THE TERRIBLE 12
I don't get it. There has never been a perfect Ten-Tec. There has never
been a perfect Icom... Kenwood.... Yaesu... Collins... whatever. Don't
say there was otherwise why did you get something else?
There are sooo many Ten-Tec products to discuss.... but so many 'others'
turned off by this continuous... "going nowhere" Orion banter. Why not
just establish bug and wishlists for each version of the firmware....
somewhere! And then get on with discussing new things?
We don't have to paint a 'rosy picture'. Discussion good and bad is
'good'. But there is a point of over doing anything. And for gosh
sakes... if you no longer have a Ten-Tec or are not planning to perhaps
get one there really isn't any reason for you to post here. It simply
isn't constructive.
Those are my thoughts.... I am about 30 seconds from removing myself
from this list as it doesn't seem to have all that much to offer those
of us that use other Ten-Tec gear and are looking for ways to use it better.
KG6TT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|