You then will solder about a 6" # 16
gauge flexible wire (use a piece of heavy lamp cord) from Pin 4 to the
Chassis ground tab which
already has a # 16 wire that connects through the pc card onto the chassis
ring of the Foster plug.
Dave: From the last part of the instructions above, follow that wire and
connect to that ground point.
73,
John N1JM
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of ke7gi Dave
Sent: Monday, May 30, 2005 12:07 AM
To: tentec@contesting.com
Subject: [TenTec] Heil Orion mod
Hi,
Has anyone on this list used the mic mod for the Orion shown on the Heil web
site?
I think I will do it-but have a question: One step says to Solder a #16
ground wire from pin 4 to chassis ground. Do they mean to the circuit board
or directly to the chassis?
I haven't opened it up yet, and the photo on the web site doesn't show where
the wire goes when connected to chassis ground. I ask because I remember a
discussion on here once about a difference in resistance to various
"grounds."
Thanks for any help.
73, Dave ke7gi
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|